تخطى إلى المحتوى الرئيسي

المشاركات المكتوبة بواسطة Brenda Gabel

Big chief : Preheating and Connecting the Battery

Big chief : Preheating and Connecting the Battery

Using a big chief vape cartridgebig chief extracts cartridge for the first time is not always intuitive. Below are some simple and clear step-by-step instructions to get you started big chief on the go quad pod how to use and prime a big chief vape cartridgebig chief cartridge, and to help you avoid many common beginner mistakes.

Step One: Unpackage and big chief thc cartridge Prime the big chief thc vapebig chief cartridge

To start, remove the cart from its packaging and big chief hemp pre rolls take off the white rubber covers on either end. There should be one cover on the mouthpiece, and another at the base over the coil.

With these pieces removed, big chief thc cartridge if your cart is working correctly, the oil should seep into the bottom of the chamber and surround the coil. This means it is ready to be primed.

Priming

To prime your cart, inhale from the mouthpiece several times. There should be no vapor, only air, and the cart should not be attached to a battery. Take between 5-8 "dry hits" in this way, pulling air through the chamber and up into your mouth.

Next, big chief cherry pie rub the cart between your palms quickly to loosen the oil. If the oil remains above the chamber, simply continue both priming steps until corrected.

Users often overlook the priming process, but it helps prepare the cart for use, and will help prevent clogging in the future.

Step Two: Preheating and Connecting the Battery

With the cart primed, big chief extracts cartridge the next step is to preheat it by hand or big chief on the go quad pod attach it to a battery and big chief hemp pre rolls preheat the oil.

Here, please be sure you are using a 510-battery that is fully charged. All 3CHI big chief thc vape cartridges are designed to be used with a 510-threaded battery. Improper batteries, including MOD batteries, can easily burn or otherwise damage the cartridges.

Preheating

If your compatible battery does not have a preheat button, you will need to preheat by hand. This can be done by rubbing the big chief thc cartridge between your palms, or trainwreck big chief by gently and big chief hemp pre rolls carefully using a blowdryer to warm the oil. Set the dryer to low heat and gently move the mouth up and down the cart from a distance of approximately eight inches.

  • مشاركة